Horizontal machining center refers to a machining center where the table and the spindle are set in parallel. The horizontal machining center usually has three linear motion coordinate axes plus a table rotation axis. The horizontal machining center can automatically select different tools according to the program after clamping the workpiece at one time, automatically change the speed of the spindle, and complete the processing of multiple processes on multiple surfaces in sequence according to the programming sequence. This type of machining center is most suitable for processing the box Category parts. Next, the editor introduces four major points to note when using a horizontal machining center.
Environment in which horizontal machining center is installed
The horizontal machining center should be installed in a place away from the source of the earthquake, not exposed to direct sunlight, no heat radiation and no humidity. If there is an earthquake source near the place where the horizontal machining center is installed, anti-vibration trenches should be installed around the horizontal machining center. If the anti-vibration groove is not installed, it will directly affect the processing accuracy and stability of the horizontal machining center. Over time, it will affect the poor contact of electronic components, malfunction, and the reliability of the horizontal machining center.
Strict control of voltage and current
Horizontal machining centers are generally installed in the processing workshop, and there are many mechanical equipment in the processing workshop, which inevitably leads to large fluctuations in the power grid. Therefore, the installation position of the horizontal machining center must strictly control the voltage and current of the power supply. The voltage and current of the power supply must be controlled within the allowable range of the horizontal machining center. The voltage and current of the power supply must be stable, otherwise it will directly affect the horizontal Normal operation of the machining center.
Temperature and humidity will directly affect the horizontal machining center
Horizontal machining centers generally work in environments below 30 degrees Celsius. In general, the distribution box of the horizontal machining center is equipped with exhaust fans and coolers to ensure that the electronic parts and central processing work at a constant temperature. . If the temperature and humidity are too high, the life of the components of the control system will be reduced, and the failure of the horizontal machining center will increase for no reason. If the humidity is increased, dust will increase on the integrated circuit board, which directly leads to poor contact and short circuit faults.
Machine tool factory parameter settings
When using a horizontal machining center, the customer cannot change the factory parameter settings of the machine tool at will, because these factory parameter settings directly affect the dynamic characteristics of each component of the horizontal machining center, and only the gap compensation parameter value can be set according to the actual situation. If you want to change the factory setting parameters, you should contact the manufacturer and change the factory setting under the guidance of the manufacturer’s technical personnel.
