Our Blog

What is the non-contact magnetic identification method of the CNC machining center factory? The magnetic identification method uses the magnetic induction and the magnetic induction of the non-magnetic material to be different, and reads the code through the induction coil.

The structure of the contact code recognition device of the CNC lathe factory is simple, but the reliability is poor, the life is short, and the tool cannot be selected quickly. Contact code identification device of CNC lathe factory. Two

Why the bottom surface and both sides of the groove of the rocker drilling machine are not parallel to the axis of the workpiece? The reasons for the bottom surface of the groove of the rocker drilling machine and the

The hydraulic transmission system occupies a very important position in CNC machine tools. The automatic tool change system (ATC) of the machining center, the automatic pallet exchange system, the balance of the spindle box, the gear shift of the spindle

Fault phenomenon: When changing the tool of the TH5840 vertical machining center, the spindle cone hole is blown to blow out the water molecules containing rust, and attached to the spindle cone hole and the tool shank. Poor contact between

The spindle drive system produced by FANUC can be divided into two categories: DC spindle drive system and AC spindle drive system. DC spindle drive systems are usually used on CNC machine tools before the 1980s, and are mostly used

At present, the automatic tool changer (ATC) of the machining center has two common types of tool change. One is that the tool is directly exchanged from the tool magazine by the spindle, and the other is to rely on

A CNC drilling and milling machine equipped with SIEMENS 802S shows normal changes during manual operation, but the actual coordinate axis does not move and the system has no alarm display. Analysis and processing process: After inspection, the driving stepper

Fault phenomenon: A CNC machine tool with the model FANUC 0MC and model XH754, when changing the tool, the claw did not pull out the tool in the spindle, and alarmed.Analysis and processing process: The possible reasons why the claw

In the case of the original backup parameters of the machine tool manufacturer (or the system parameters backed up when the system is good) 1. Shut down and disconnect the machine power 2. Set RSW2 to C (RSW2 rotary switch